4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709Email: [email protected] • visit us at www.MartinUniversalDesign.comM
After sliding Drawer into table, you need to install the drawer stop (Part X). This can be a bit tricky.You need to position the Drawer Stop (Part X)
NOTE: The photo at the left show the table laying top down on the carpeted floor and standing above the table looking downward.Slightly lift the table
Once Side Shelf is positioned correctly, secure shelf using 3 wood 4x30mm screws (Part R) in the holes indicated in FIG 21. Use a Philli
STEP 1] Assemble DrawerBegin by taking the back panel of drawer (Part Y) and inserting 1 plastic T-nut (part K) into each hole, making sure the hole
STEP 4] Assemble Drawer, cont’dAttach sides of drawers (Parts A1L & A1R) to the Drawer front (Part Z) by inserting Threaded Connection Pin
May 08- RPIPg. 4 STEP 7] Attaching Drawer HandleAttach drawer handle (Part L) to drawer, using 2 each 4x18mm screws (Part Q). See FIG HInsert screws (
STEP 1] Assembly Base of TableBegin by assembling the base by taking the left side (part A) and attaching the three cross supports (p
Pg. 6May 08- RPIManchester Split-top Table Assembly InstructionsRepeat with right side (part B) by attaching the other end of the three cross supports
Pg. 7May 08- RPIManchester Split-top Table Assembly InstructionsAttach lower wider Cross Support (part F) to lower portion of base by lining u
Manchester Split-top Table Assembly InstructionsAttach Drawer support guide (Part G) to base cross supports (part C & E) using 2 each 6x30mm He
After lining up holes, attach tilt mechanism (Part J) to top with 2 each 6x8mm Hex Bolts (Part P). Tighten with Allen Wrench. See FIG 15. STEP 11] At
Kommentare zu diesen Handbüchern